Sismo Hardware

1 General information

The new release of ProSim:737 2.X does not require use SC-Pascal Scripts to control the Sismo´s Plug&Fly Modules Ethernet using SimCards.

The application recognizes automatically the module based on the Host Port.

Please refer to the manual provided by Sismo - USING PROSIM737 V2.X WITH SISMO MODULES ETHERNET

2 Supported specific hardware

2.1 GENERAL CONFIGURATION

1. In ProSim737 System->Config->Configuration->Drivers enable the option "Sismo ethernet boards support"
2. Restart ProSim737

2.2 MIP

• See General configuration
• In ProSim737 System->Config->Configuration->Drivers, click on "Advanced" button next to "Sismo ethernet boards support", in the new window, select !MIP" tab and enabled the panels you have connected

2.3 Fwd Overhead

• See General configuration
• In ProSim737 System->Config->Configuration->Drivers, click on "Advanced" button next to "Sismo ethernet boards support", in the new window, select "Fwd OVH" tab and enabled the panels you have connected

2.4 Fwd Overhead

• See General configuration
• In ProSim737 System->Config->Configuration->Drivers, click on "Advanced" button next to "Sismo ethernet boards support", in the new window, select "Aft OVH" tab and enabled the panels you have connected

2.5 Pedestal

• See General configuration
• In ProSim737 System->Config->Configuration->Drivers, click on "Advanced" button next to "Sismo ethernet boards support", in the new window, select "Aft OVH" tab and enabled the panels you have connected

2.6 MCP

• See General configuration
• In ProSim737 System->Config->Configuration->Drivers, click on "Advanced" button next to "Sismo ethernet boards support", in the new window, select "MCP" tab and enable the EFIS you have connected
• No configuration required in ProSim737-MCP - but the MCP software must be running

3 Troubleshooting

TBA