SimWorld Hardware
Contents
1 General information
Overhead, MIP, Gauges and MCP is supported. MIP, Pedestal, Gauges and MCP is connected with CAN bus technology. A power cable and CAN bus ‘connection’ cable will be connected to a “SimBox”. The SimBox will be connected to the primary computer. The IO modules will be connected automatically when the "SimWorld hardware support" is enabled in the driver page (see below). The USB should be connected as HID device without any driver installed.
2 Supported specific hardware
2.1 FWD & AFT Overhead
Overhead panels are connected directly with USB interface and not through "SimBox". In ProSim737 System->Config->Configuration->Drivers enable "SimWorld hardware support" Restart ProSim737 Systems Both panels are PnP and don't require any further configuration.
2.2 CDU
CDU is connected through SimBox and CAN bus cable. "SimWorld hardware support" must be enabled in ProSim737 System Correct role (capt/fo) must be configured in the ProSim737 CDU to match the hardware configuration
2.3 MCP/EFIS
CDU is connected through SimBox and CAN bus cable. "SimWorld hardware support" must be enabled in ProSim737 System No configuration neccessary in ProSim737 MCP, but ProSim737 MCP must be running
2.4 MIP
MIP is connected through SimBox and CAN bus cable. "SimWorld hardware support" must be enabled in ProSim737 System MIP is PnP and don't require any further configuration.
3 Troubleshooting
3.1 ProSim737 panel
TBA
