PoKeys

1 General information

ProSim supports both USB and LAN versions of the PoKeys card.

PoKeys drivers need to be installed first, please refer to the manual.

2 GENERAL CONFIGURATION

• In ProSim737 System->Config->Configuration->Drivers enable the option "Pokeys USB and ethernet support"
• Restart ProSim737
• All connected devices should be listed in the main ProSim737 System window in the "IO Modules" field

3 ADVANCED CONFIGURATION

• Autoconfigure cards (enabled by default) - because each port on the PoKeys card is multifunctional, it needs to be defined whether it's input or output pin. This could be done automatically by ProSim according to the assignments (in this case leave this option enabled) or manually using PoKeys configuration software (disable this option).
• Use fast interface if available (enabled by default) - disable only when experiencing issues with stability
• Poller Enabled (enabled by default) - only relevant for PoKeys USB - when this option is enabled, ProSim scans for new cards in regular interval. This option should be disabled after the configuration is finished.

4 Supported generic hardware

• PoKeys57E (ethernet)
• PoKeys57U (USB)

4.1 Digital inputs

• See General configuration
• Assign in ProSim737 System->Config->Configuration->Combined Config

4.2 Digital outputs

• See General configuration
• Assign using the output finder in ProSim737 System->Config->Configuration->Combined Config

4.3 Analog inputs

• See General configuration
• Assign and calibrated in ProSim737 System->Config->Configuration->Combined Config

5 Troubleshooting

TBA